Recalling And Clearing Stored; Measurements/Calculations - General LDM60 User Manual

5. Move the meter to an adjacent wall of the room or space and
hold its rear against that wall. Aim the laser at the opposite
wall and press the
appear on the third line of the display and the volume of the
room or space—in "cubic" units—will appear on the bottom
line. The final display will look similar to Fig.13.
Fig. 13. Calculation of the volume
of a room measuring
3.959 x 2.898 x 5.106 meters

RECALLING AND CLEARING STORED

MEASUREMENTS/CALCULATIONS

The LDM60 automatically stores its last 20 measurements or
calculations and retains them in memory after being powered
off. The records also are unaffected by a battery discharge or
battery change. Once the memory is full, the next measurement
or calculation overwrites the oldest record in a first in-first out
(FIFO) scheme. Record #1 is the most recent measurement or
calculation, and Record #20 is the oldest. The records are
recalled sequentially, using the front-panel + and — buttons.
24
button. The distance measured will
MEAS
3.959
2.898
5.106
58.582
3