A & D Board Removal - Sony Trinitron CPD-G220R Service Manual

1-3. A & D BOARD REMOVAL
7
6
5
Remove (1) screw (+BVTP 3 x 8) from the rear
of the EMI shield.
Remove (2) screws (+BVTP 3 x 8) from the sides of the
EMI shield. Lift and remove.
Remove (1) screw (+BVTP 3 x 8) from the cable holder
at the rear of the chassis base to release the cable.
Remove (2) screws (+BVTP 3 x 8) from the rear of the
chassis base and remove.
Remove (1) screw (+BVTT 4 x 8) from the audio bracket,
and remove (CPD-G220S Only).
Remove (2) screws (+BVTP 4 x 16) from the chassis
base and slide out to remove.
Remove (7) screws (+BVTP 3 x 8) from the D Board.
7
Lift the board up and out to remove.
Carefully remove the solder connections, and remove
8
the shield cover from the A board
Gently wiggle the A board back and forth, and pull it to
remove.
4
3
— 6 —
CPD-G220R/G220S
9 8
2
1