Subaru LEGACY 2004 Service Manual page 50

SECURITY AND LOCKS
4) While pressing the button of keyless transmitter
to be registered twice with door lock switch pressed
to UNLOCK. (Button for LOCK, UNLOCK and
TRUNK are acceptable)
5) When the registration is completed normally, the
door lock actuator will lock → unlock. If the lock →
unlock operation is not carried out, repeat the pro-
cedure 4).
NOTE:
• When pressing the keyless transmitter button,
slowly press for first and second (press longer for
second) to check operation of door lock actuator.
• Do not press the button of keyless transmitter
more than twice.
• Do not batter the button of keyless transmitter.
6) Repeat the steps 4) if there is an additional key-
less transmitter to be registered.
7) Pull out the registration connector, and install the
lower trim cover at driver's side.
NOTE:
• The transmitter can be registered only when the
door lock switch is remain pushed to UNLOCK.
• Continuing to press the door lock switch to UN-
LOCK again allows to be registered although the
door lock switch is released for once.
• When adding the keyless transmitter, re-registra-
tion of keyless transmitter which was already regis-
tered is necessary.
2. CLEAR OF KEYLESS TRANSMITTER
1) Remove the keyless transmitter from ignition
switch.
2) Remove the lower trim cover at driver's side,
then connect the registration connectors. (1 pole
white connector)
3) Press the door lock switch located under the
power window main switch to LOCK. (Make sure
the room light blinks and buzzer sounds, and sys-
tem becomes in clear mode.)
4) While pressing door lock switch to LOCK, insert
and remove the key on ignition switch 10 times
within 10 seconds.
5) When the clearing is completed normally, the
door lock actuator will lock → unlock. If the lock →
unlock operation is not carried out, repeat the pro-
cedure 4).
6) Pull out the registration connector, and install the
lower trim cover at driver's side.
NOTE:
• The transmitter can be cleared only when the
door lock switch is remain pushed to LOCK.
• Continuing to press the door lock switch to LOCK
again allows to be cleared although the door lock
switch is released for once.
Keyless Transmitter
• If changing from registration mode to clear mode,
you cannot go to clear mode unless completing the
registration mode. The reverse case is same as
this.
SL-48