Advertisement
DXGLO2 2kW Fan Heater
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
DO NOT use the heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
DO NOT place the heater directly below a fixed
socket outlet.
The socket-outlet must be accessible at all times
to enable the mains plug to be disconnected as
quickly as possible.
DO NOT COVER or obstruct the air inlet and
outlet openings in any way.
The heater must be on a flat stable surface when
in use.
DO NOT operate the heater with the mains lead
overhanging the front outlet grille.
The Heater carries the warning symbol
indicating that it must not be covered.
WARNING: In order to avoid overheating do not
cover the heater.
IMPORTANT: If the mains lead of this appliance is
damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person
in order to avoid a hazard.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience or knowledge if they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Children of less than 3 years should be kept away
unless continuously supervised.
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning the
use of the appliance in a safe way and understand
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user
maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
IMPORTANT: Avoid use of an extension cord
because the extension cord may overheat and
cause risk of fire.
DO NOT use the heater on deep pile carpets or
the long hair type of rugs, or less than 750mm
(30") away from any overhanging surface. Keep
combustible materials such as drapes and other
furnishings clear from the front, sides and rear of
the heater.
DO NOT use heater to dry your laundry.
The instruction leaflet belongs to the appliance
and must be kept in a safe place. If changing
owners, the leaflet must be surrendered to the
new owner.
DO NOT operate the heater with the mains lead
overhanging the front outlet grille.
Electrical connection
This heater must be used on an A.C.~ supply only and the
voltage marked on the heater must correspond to the supply
voltage. This heater is fitted with a plug incorporating a 13
amp fuse. When replacing the fuse, a 13 amp fuse approved
by ASTA to BS 1362 must be used.
If the plug is not suitable for the socket outlets in your home,
the plug must be cut off and an appropriate one fitted. A
plug cut off from a mains lead will give a shock hazard if
inserted into a 13 amp socket elsewhere in the house. To
avoid this, it should be disposed of immediately.
NOTE: The fuse cover of a non-rewirable plug must be
refitted when changing the fuse. Should the cover become
lost, the plug must not be used until the correct replacement
fuse cover is obtained from your supplier or by contacting
our customer helpline.
IMPORTANT : The wires in this mains lead are coloured
in accordance with the following code:
BLUE:
NEUTRAL
BROWN :
LIVE
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows :
Connect the BROWN wire to the terminal marked 'L' or
coloured RED. Connect the BLUE wire to the terminal
marked 'N' or coloured BLACK. Note : 'L' or 'N' must not
be connected to the EARTH terminal marked 'E' or
coloured GREEN or GREEN AND YELLOW.
If in doubt, consult your electrician.
or
Advertisement
