Table of Contents
Advertisement
4. Click the Scan button. Part of the document image will be displayed in the
Alignment Window.
5. Click the Alignment Position buttons (Up, Down, Left, Right) until the top left
corner of the scanned document aligns with the top left corner of the Alignment
Window.
6. When the alignment completes, click on OK button to save settings and exit.
P
S
OWER
AVE
You may opt to keep the scanner lamp always on or define an idle time for the
scanning lamp to automatically turn itself off.
Information
1. Right click the icon
Utility from the menu that pops up.
2. In the Power Save Mode section of the Scanner Utility window that opens,
click the button of your option:
a. To set the lamp being always illuminated: Click the button before "Keep
lamp always on".
b. To automatically turn the lamp off: Click the button before Turn lamp off
after the scanner has been idle for ... minutes and then click the up or
down arrows to set a default time for the lamp to automatically turn off after
a scan.
3. Click on OK button to save settings and exit.
Warning
The default value of the delay time for the lamp
to automatically turn off after a scan is less than
10 minutes. The default value may vary
depending on the scanner model you purchase.
on the Windows system tray and select Scanner
To completely shut down the scanner,
switch off the power from the rear of the
scanner.
If the scanner will not be used for a long
period of time, shut down the scanner and
then disconnect the power cable from the
power outlet.
32
Advertisement
Table of Contents
