APPLIANCE DIMENSIONS
Figure 1
RIGHT SIDE
LEFT SIDE
FRONT
INSTALLATION CODES
This appliance is a Direct Vent appliance which draws all combustion air from outside the building
through an intake vent pipe.
Installation must conform to local codes. In the absence of local codes, installation must conform to
the National Fuel Gas Code, ANSI Z223.1, or the current CSA B149. Installation Codes. The unit,
when installed, must be electrically grounded in accordance with local codes or, in the absence of
local codes, with the National Electric Code ANSI/NFPA No. 54 or with the current CSA C22.2
Canadian Electrical Code. In the state of Massachusetts, this product can only be installed by a
licensed plumber or a licensed gas fitter. Failure to comply will void the warranty.
This appliance has been certified for use with natural gas only.
This appliance is not for use with solid fuels.
CODES D'INSTALLATION
Cet appareil est un appareil à évent direct, qui attire tous l'air de combustion provenant de l'extérieur
du bâtiment par une entrée d'évent.
L'installation doit se conformer aux codes locaux. Dans l'absence de codes locaux l'installation doit
se conformer au Code de Gaz du Combustible National, ANSI Z223.1, ou l'actuel CSA B149 Au
moment de l'installation, cet appareil doit être branché et mis à terre conformément aux codes locaux
,ou en l'absence de codes locaux, au code Canadien de l'électricité CSA C22.2 ou au code National
de l'électricité ANSI/NFPA 54 si l'installation est faite aux États-Unis.
Cet appareil a été certifié pour une utilisation au gaz naturel uniquement.
Cet appareil n'est pas pour une utilisation avec des combustibles solides.
Page 7 of 53