Savannah Tasman DVI26,000 Installation And Operating Instructions Manual page 20

3/. From the roof, pull the liners and fit the roof flashing in place.
4/. Fit the termination cap making sure that the exhaust liner is connected to the exhaust vent collar.
Make sure the termination and venting are sealed from water penetration with an approved sealant.
REMOVAL AND REINSTALLATION
If the fireplace is removed at any time by disconnecting the slider on the top holding the intake and
exhaust pipes, the gasket between the fireplace and the slider must be replaced with a new gasket #
IMC161
Figure 5
Reattach firmly with
lock-in screws
Gasket IMC161
must be replaced
on reinstallation
Joint IMC161
doit être remplacé
sur la
réinstallation
Page 20 of 53