Fluke 414D User Manual page 30

414D/419D/424D
Users Manual
424D (2 Values)
You can enter two different distances (a and b) into the
Meter and use them to mark off measured lengths, for
example, in the construction of wooden frames.
To find stake out distances with 2 values:
r

1. Push 4x. shows in the display.
 
2. Push and to increase and decrease the
values that shows on the display.
The value (a), and the intermediate line that
corresponds, blink on the display.
 
3. Push and to adjust the (a) value.
Note
Hold the buttons down to increase the rate of
change for the values.

4. Push to accept the (a) value.
 
5. Push and to adjust the (b) value.

6. Push to accept the (b) value.
The display shows the stake out distance in the
summary line between the stake out point (a and
then b) and the Meter (rear reference).
24
MyFlukeStore
www.
Shop for Fluke products online at:
7. Move the Meter slowly along the stake out line the
displayed distance decreases.
The arrows in the display
direction the Meter needs to be moved in order to
achieve the defined distance (either a, or b).
Note
It the beeper feature is on, the Meter starts to
beep at a distance of 0.1 m (4 in) from the next
stake out point. As the Meter moves near to the
stake out point, the beep changes and the
arrows do not show on the display.

8. Push to stop the stake out function.
1.877.766.5412
.com
q
indicate in which