IBM Netfinity 4500R User Reference Manual page 144

Code Function
264 Magnetic tape
drive
301 Keyboard
302 Mouse
Table 17. Diagnostic error messages
132
IBM® Netfinity® 4500R User's Reference
Result
Aborted Test setup error: No tape drive found
Failed The load/mount test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
The Self-diagnostic failed for device n on adapter
m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for
device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device
n on adapter m
(where n is the number of the device and m is the
adapter number)
Failed On system board keyboard test failed
Failed On system board pointing device test failed.
Text message Action
Check the cable and
power connections to
the drive.
Refer to the
information that is
provided with the tape
drive.
If the problem persists,
call for service.
Refer to the
information provided
with the tape drive.
If the problem persists,
call for service.
Note: The push
button test is
applicable
only to SCSI
tape drives
that have a
push button.
Insert a new tape
cartridge; then, run the
diagnostic test again.
Refer to the
information that is
provided with the tape
drive.
If the problem persists,
call for service.
1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace
the keyboard
cable.
If the problem persists,
call for service.
Replace the pointing
device. If the problem
persists, call for
service.