19
Take plate with glass and place over
the 2 screws and twist to hold in
place. Replace screw removed.
22
Attach blade arms to blades using
the blade arm screws and washers
provided.
25
Remove the 3 screws holding plates
together if not using light kit, to
seperate lower cover plate from light
plate.
28
Loosen 2 screws with slots, remove
one screw and place plate over holes
and twist into place. Replace the
screw removed and tighten all screws
securely.
20
Tighten all 3 screws securely.
23
Check the motor for plastic shipping sta-
bilizer tabs and remove if they are pres-
ent. The screws, washers and motor pads
are pre-installed to the blade holders.
Attach blade assembly to motor and
tighten screws securely.
26
Install lower cover plate over loos-
ened screws and twist lower cover
plate with key hole slots into place.
If not using light kit push wires up
and tighen all 6 screws securely.
29
Loosen 2 screws and remove 1 screw
on light kit cover.
21
Place floating brackets onto blades
aligning holes in blade with the float-
ing bracket.
24
Loosen 2 screws and remove 1
screw to allow bottom fan plate to
be installed. If attaching light kit skip
to step 28.
27
Attach center cover plate by screw-
ing into center of fan
30
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.