C2 Motor Phase Classification Coding Setting - KUNTENG KT-LCD3 Product User Manual

Forward 8 Signal
Forward 10 Signal
After finishing C1 parameter setting, hold
current set values and enter C2 parameter setting interface.
○

C2 Motor Phase Classification Coding Setting

Enter C2 parameter setting interface after C1 parameter setting is finished, C2
parameter column flashes.
C2 is motor phase classification coding setting, it is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used. C2 setting
range is 0-7, hold
After finishing C2 parameter setting, hold
current set values and enter C3 parameter setting interface.
ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
02 Lowest
00 Higher
01 Standard
02 Lower
00 Highest
01 Higher
02 Standard
C2 parameter setting interface
button (UP) or
Reverse 10 Signal
Reverse 12 Signal
button (SW) shortly to save the
button (DOWN) for selection.
button (SW) shortly to save the
- 24 -
07 Lowest
05 Higher
06 Standard
07 Lower
05 Highest
06 Higher
07 Standard