Setting; General Parameters; Time Of The Day - Honeywell KS20S KaltecSoft Evolution Operation Manual

8. Setting

Display and operating keys
1 2
8 7
Img. 7 Display and operating keys
1. Confirmation of water flow (detected from water meter)
2. Name of parameter
3. Value of parameter
4. "Confirm and Go ahead" button
5. Decreasing button
6. Increasing button
7. Regeneration button / back button
8. Clock button

8.1. General parameters

The initial display shows general parameters alternating
between TIME OF DAY, CAPACITY REMAINING, DAYS TO
A REGEN, FLOW RATE and Installer name and phone
number, if set
Note! An asterix (*) is displayed, if the water meter
detects a water flow.
1. Push to start scrolling through the parameters.
Note! TIME OF DAY alternates with REGEN TODAY,
if a regeneration is expected today.
2. Each push on displays another parameter in the
following sequence:
• CAPACITY REMAINING
• DAYS TO REGEN
• FLOW RATE
• Installer name and phone number, if set.
MU5H-1419GE23 R0815
3
6 5 4
8.1.1. CAPACITY REMAINING
You can change the remaining capacity of the KS20S
softener.
1. Push to go to the next parameter
The display shows CAPACITY REMAINING.
2. Push to decrease the capacity.
Each push decreases the capacity by 0.01 m³
8.1.2. DAYS TO REGEN
You can change the number of days till the next regeneration.
1. Push to go to the next parameter
The display shows DAYS TO REGEN
2. Push to decrease the number of days.
Each push decreases the days until the next regeneration
by 1.
8.1.3. FLOW RATE
The current flow rate of the KS20S softener is shown in LPM
(liters per minute).
8.1.4. Installer data
The display will show the name and the phone number of the
installer, if set.

8.2. Time of the day

1. Push to set the time
The display shows TIME HOUR and the current hour flashes.
2. Push or
3. Push to go to the next parameter.
11
to adjust the hours.
Honeywell GmbH