Sony DCR-PJ5 Handycam Operating Manual page 47

unnecessary images (p. 20).
Total number of movie scenes or photos has

exceeded the recordable capacity of your
camcorder. Delete unnecessary images (p. 20).
The recording stops.
The temperature of your camcorder is

extremely high/low. Turn off your camcorder
and leave it for a while in a cool/warm place.
"PMB" cannot be installed.
Check the computer environment or

installation procedure required to install
"PMB" (p. 33).
"PMB" does not work correctly.
Quit "PMB" and restart your computer.

The camcorder is not recognized by the
computer.
Disconnect devices from the USB jack of the

computer other than the keyboard, mouse,
and your camcorder.
Disconnect the USB cable from the computer

and your camcorder, and restart the computer,
then connect the computer and your
camcorder again in an orderly manner.
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen,
check the following.
If the problem persists even after you
have tried to fix a couple of times, contact
your Sony dealer or local authorized Sony
service facility. In this case, when you
contact them, give them all the numbers of
the error code beginning with C or E.
C:04:
The battery pack is not an "InfoLITHIUM"

battery pack V series. Use an "InfoLITHIUM"
battery pack (V series).
Connect the DC plug of the AC Adaptor to

your camcorder securely (p. 13).
C:06:
The battery pack temperature is high. Change

the battery pack or place it in a cool place.
C:13: / C:32:
Remove the power source. Reconnect it and

operate your camcorder again.
E::
Follow the steps from  to  on page 46.

The indicator flashes when the internal hard

disk of your camcorder becomes full. Delete
unnecessary images (p. 20), or format the
internal hard disk (p. 54) after storing the
images on other media.
An error may have occurred with the internal

hard disk of your camcorder.

Battery power is low.

The battery pack temperature is high. Change

the battery pack or place it in a cool place.
The temperature of your camcorder is getting

high. Turn off your camcorder and leave it in
a cool place.
The temperature of your camcorder is low.

Make the camcorder warm.
No memory card is inserted (p. 14).

The indicator flashes when the memory card

US