Working With Cables - IBM eServer 330 xSeries Installation Manual

3. Install the cover by placing it into position and sliding it forward. Make sure that
4. Install the screws and secure the cover as shown.
5. Install the server in the rack. See the Rack Installation Instructions that come with
6. Continue with "Working with cables" for the instructions needed to cable the
Notes:
1. Depending on the options that you installed, you might need to run the
2. If you installed a SCSI drive, check the lights to verify proper operation.

Working with cables

Your server has two different cabling options, the Advanced System Management
(ASM) bus and the Cable Chain Technology (C2T). The following sections discuss
each of these options. While reading about these options, keep in mind that they are
independent of each other.
1. Refer to the following illustration to locate the connectors on the back of your
the cover engages the tabs at the front and rear of the server.
your server.
server.
Configuration/Setup Utility program to complete the server configuration. See the
User's Reference for more information.
server.
Ethernet 1 speed
indicator (green)
Ethernet 1 link
indicator (green)
Ethernet 2 link
indicator (green)
Ethernet 2 speed
indicator (green)
The ASM ports on the back of the server are referred to in this book as
RS-485 (A) and RS-485 (B).
Advanced System
Management RS-485 connectors
C2T (Out) connector
Select light (green)
USB 2
connector
C2T (In) connector
USB 1
Power-on
connector
light (green)
System error
light (amber)
Chapter 2. Installing options
Screws
Serial connector
15