Working With Memory - IBM eServer 330 xSeries Installation Manual

8. Install the adapter:
9. Connect the internal cables to the adapter.
10. If you have other options to install, install them now. Otherwise, continue with

Working with memory

Your xSeries 330 supports 128 MB, 256 MB, 512 MB, and 1 GB DIMMs. See the
ServerProven list at http://www.ibm.com/pc/compat for a list of memory modules for
use with your server.
8
IBM® xSeries 330: Installation Guide
a. Open the adapter-retention latch by pushing the blue tab to release it. Then,
push the latch up to the full open position.
b. Carefully grasp the adapter by its top edge or upper corners, and align it with
the connector on the PCI riser card.
c. Press the adapter firmly into the riser-card connector.
Attention: When you install an adapter, be sure that the adapter is correctly
seated in the riser-card connector before you turn on the server. Improperly
seated adapters might cause damage to the system board, the riser card, or
the adapter.
d. Push down on the blue adapter-retention latch until it clicks into place,
securing the adapter.
e. Replace the expansion-slot clip by sliding it down until it latches into place
and holds the adapter securely.
Attention: Route cables so that they do not block the flow of air from the fans.
Extra cable
length
SCSI connector
(J4)
"Installing the cover" on page 14.
ServeRAID
adapter