Download Print this page

Maintenance; Operation - Craftsman 315.108470 Operator's Manual

7-1/4 in. double insulated
Hide thumbs

Advertisement

OPTIONAL DUST NOZZLE KIT
See Figure 23.
An optional dust nozzle kit, part no. 982829-001, is
available for purchase at your nearest Sears Retail
Store. As shown in Figure 23, the adapter fits over the
dust chute which is located on the upper blade
guard.The nozzle attaches to the adapter.
Note: If you use the nozzle, you should always
connect it to a standard vacuum hose.
TO ATTACH DUST NOZZLE KIT
■ Unplug your saw.
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
■ Orient adapter to fit into the dust chute opening (1)
on upper blade guard. Secure adapter with screw
(2) provided.
■ When using a vacuum hose, align hole in nozzle
with raised lip on adapter and snap into place (3).
GENERAL
Only the parts shown on parts list, page 21, are
intended to be repaired or replaced by the customer.
All parts represent an important part of the double
insulation system and should be serviced only at a
Sears Service Center.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, carbon
dust, etc.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken or
destroy plastic.

OPERATION

DUST
CHUTE
HOLE

MAINTENANCE

It has been found that electric tools are subject to
accelerated wear and possible premature failure when
they are used on fiberglass boats, sports cars,
wallboard, spackling compounds, or plaster. The
chips and grindings from these materials are highly
abrasive to electric tool parts, such as bearings,
brushes, commutators, etc. Consequently, it is not
recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds, or plaster. During any use on these
materials, it is extremely important that the tool is
cleaned frequently by blowing with an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high-grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further lubrication is required.
WARNING:
safety glasses with side shields during power tool
operation or when blowing dust. If operation is
dusty, also wear a dust mask.also wear a dust
mask.
17
BLADE GUARD
1
ADAPTER
RAISED LIP
SCREW
3
2
NOZZLE
Always wear safety goggles or
UPPER
Fig. 23

Advertisement

loading

  Related Manuals for Craftsman 315.108470