Additional Information - Sony WEGA KV-AR29 Operating Instructions Manual

Connecting a DVD player to the component video input
terminal (
1 Using an audio cable, connect R and L under
TV to the LINE OUT, AUDIO R and L output connectors on your DVD player.
2 Using a component video cable, connect Y, C
(component video input) on your TV to the COMPONENT VIDEO OUT Y, C
and C output connectors on your DVD player.
R
3 Press DVD on the remote to watch the
will appear on your screen.
DVD player
COMPONENT VIDEO OUT
C C Y
R B
Notes
• If your DVD player can ouput interlace and progressive mode signals, select the interlace
output when connecting to
either 525i/60Hz or 625i/50Hz interlace signals.
• Some DVD player terminals may be labeled differently:
Connect
Y (green)
C (blue)
B
C (red)
R
• When both (S video) and
(S video) is automatically selected. To view
• If you select "DVD" on your TV screen, the signal from the T (monitor output) jacks will not
be output properly. This does not indicate a malfunction.
01GB08ADV-OCE.p65
)
S VIDEO OUT LINE OUT
R-AUDIO-L VIDEO
Audio cable (not supplied)
Component video cable (not supplied)
(component video input) on your TV. Your TV can receive
To (on the DVD player)
Y
C , P , C or B-Y
B B b
C , P , C or R-Y
R R r
(video) for t 1 or t 3 are connected at the same time,
29
Sony KV-AR29M31 Group R9 (
(component video input) on your
, and C under
B R
(component video input) and "DVD"
TV rear panel
R
(video), disconnect the S video cable.

Additional Information

27/1/03, 9:38 AM
GB
) 4-090-530-11 (1)
,
B
L Y C C
B R
29