The Radio - Panasonic RX-ES29 Operating Instructions Manual

The Radio

Preparation:
≥
When using batteries, press
≥
Press [TUNER BAND] to select "FM" or "AM".
Manual tuning
[1] Press [REW/–/
6 5
] or [
To tune automatically
Press and hold [REW/–/6] or [5/+/FF] until the
frequency starts changing rapidly.
≥ Auto tuning may be interrupted when there is excessive
interference.
≥ To cancel auto tuning, press [REW/–/6] or
[5/+/FF] once again.
[2] Press [+, – VOLUME] to adjust volume.
To use auto scan
You can search for a station by listening to all tuned-in stations
for 8 seconds each.
[1] Press [AUTO SCAN].
[2] Press [AUTO SCAN] when you find the desired
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve FM sound quality
Press [PLAY MODE] to display "
Monaural sound is selected and noise reduces when reception is weak.
Press [PLAY MODE] again to cancel the mode.
≥
To improve reception
FM : Change the length and direction of the antenna.
AM : Change the direction of the unit.
FM
≥ AM reception is briefly interrupted if [< DECK] is pressed.
≥ To improve reception when using the unit in a building or
vehicle, place it near a window.
[ ]
.
POWER POWER
/+/FF] to select a station.
".
AM
To receive FM broadcasts allocated in 0.1MHz
Main unit only
First press [TUNER BAND] to select "AM". Now, press and
hold [TUNER BAND]. The display changes in a few seconds to
show the current lowest FM frequency. Continue to hold down
the button. The minimum frequency changes and the step is
changed at the same time. Changing the step erases all preset
stations. Repeat the above to change the step back.
Preset tuning
Up to 16 stations can be set in the FM and AM band.
[1] Press [REW/–/
6
] or [
required station.
[2] Press [ MEMORY CLEAR].
[3] While "
" is flashing
Turn [TIME/PRESET TUNE
channel and press [ MEMORY CLEAR] or on remote control,
press the numeric buttons to select channels.
≥ For channels 1 to 9, press the corresponding number.
≥ For channels 10 to 16, press [S10], then the two digits.
" goes off during presetting, return to step [1].
If "
To select channels
Turn [TIME/PRESET TUNE
select the channel or on remote control, press the
numeric buttons to select channels.
To use preset scan
You can search for a station by listening to all preset channels
for 8 seconds each.
: ALBUM] or [ALBUM 9
[1] Press and hold [C
D] until "PS" appears on the display. /
[2] Press [C : ALBUM] or [ALBUM 9
/
you find the desired channel.
Preset scan ends after searching through each preset channel
D]
once. To stop during the process, press
[ALBUM 9/
.
To skip the preset channel,
1 Select the desired station.
2 Press [ MEMORY CLEAR].
3 While "
" is flashing
Turn [TIME/PRESET TUNE
4 Press [ MEMORY CLEAR].
To select the skipped channel,
Press the numeric buttons.
5
/+/ FF] to tune to the
TRACK SKIP ] to select the
TRACK SKIP ] to
D] when
/
[C ALBUM]
/:
TRACK SKIP ] to display "– –".
/
or
7
RQT7967