HP LT3200 Service Manual page 73

Note: When replacing the cover, insert the edge of the cover into the slots on the main bracket.
LT 3700 Control Board Removal
1 Disconnect the front LVDS cable by pulling the cable from the connector.
Note: The latches are not spring-loaded on the 37-inch model.
2 Pull the small white ribbon cable straight out to remove it from the connector.
3 Remove the three screws that secure the control board cover to the unit.
4 Lift the cover from the unit.
5 Disconnect the two flat ribbon cables from the ZIF connectors at the top of the control board by flipping up the dark part of the
connector and sliding the cable out of the socket.
Note: You cannot remove the ZIF cables from the side of the unit on the 32-inch and 37-inch models.
6 Lift the board from the unit.
Note: When replacing the cover, place the lip on the back of the cover into the slot on the main bracket, and then rotate the
cover down into place.
Note: On the 37-inch model, when replacing the cover, put the cover over the board before reconnecting the screws.
HP High-Definition LCD TV Service Manual
67