How To Get Back To Normal Tv Operation After Running Diagnostics; Installation Menu - HP LT3200 Service Manual

How to get back to normal TV operation after running diagnostics

1 After the diagnostic test finishes, power off the TV and disconnect the power cord.
2 Wait for about 30 seconds; and then plug the power cord back in. The TV returns to normal mode.

Installation menu

The TVs incorporate custom menus that are accessible only through a special combination of the keys on the remote control.
These menus are not available to all users and are to be used only by trained service professionals or custom installers. These
instructions are provided as is and HP is not responsible for any damage to the TV due to improper use of these menus.
The installation menu allows you to change default setting values of current input audio and video modes. For example, to
change the picture settings for a component input, switch the TV source to component before entering this mode.
To access the Installation menu:
1 Turn the TV on.
2 On the remote, press the Menu button.
3 From the OSD, select Setup -> Time.
4 If the TV is NOT in Hotel mode, press the following key sequences: SAP/MTS -> 1 -> 3 -> 5.
5 If the TV is in Hotel mode, change input source to AV2, then press SOURCE -> 1 -> 3 -> 5.
Note: Color adjustments in this menu apply to ALL modes (Cool, Standard, or Warm). If you want to adjust the color
temperature of a single mode, you will need to adjust the White Balance settings in the Factory Menu.
Color Adj.
Color Adj.
R
G
B
Note: Each input group has the same values. The same group of inputs have the same values.
Picture Adj.
Picture Adj.
Vivid
STD
Movie
By default, the TV expects the black levels of all 480i component inputs to be at 0 IRE. Since some DVD players output
component 480i at 7.5 IRE, this menu allows an installer to change the default.
Black Level format
Black Level
72
HP High-Definition LCD TV Service Manual
STD Value
Default (values: 0~100)
Default (values: 0~100)
Default (values: 0~100)
Value
Brightness Default (values: 0~100)
Contrast Default (values: 0~100)
Saturation Default (values: 0~100)
Hue Default (values: 0~100)
Sharpness Default (values: 0~100)