Getting Started - Monessen Hearth Vent-Free Fireplace Systems DBX24C* Installation And Operating Instructions Manual

Monessen hearth vent-free fireplace systems installation and operating instructions
Table of Contents

Advertisement

Milli-Volt control has four (4) positions:
OFF -
All gas to the gas logs is shut off at the valve.
IGN -
Valve position to light/maintain a standing pilot.
ON -
Valve position to turn ON/OFF log set with remote switch/thermostat.
LOW/HI -
Variable position to control flame height (heat output). Both front and rear burners are in operation to
provide realistic glow and yellow flame.
PILOT
The gas log heater is fitted with a specially designed safety pilot light which senses the amount of oxygen available in the
room and shuts the gas log heater off if the oxygen level begins to drop below a satisfactory level. The pilot can only be relit
when adequate fresh air is available.
THERMAL GENERATOR
The milli-volt gas log pilot is fi tted with a milli-volt generator to provide power for remote activation.

GETTING STARTED

Make sure you have received all parts:
Check your packing list to verify that all listed parts have been received. You should have the following:
• Unvented gas heater
• Installation/operating instructions
• Ceramic fiber logs
Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions.
• Hand held Remote with receiver
• Wall switch with 20' wire
• Handle the gas log burner assembly by the grate only. Do not pick the unit up by
the burners.
• Gloves are recommended when handling ceramic fi ber logs to prevent skin irritation
from loose fi bers. Logs are fragile — handle with care.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts
in good condition.
What you will need for installation:
You must have the following items available before proceeding with installation:
• External regulator (for propane/LPG only)
• Piping which complies with local codes
• Phillips head screwdriver
• Pipe sealant approved for use with propane/LPG
(Resistant to sulfur compounds)
33D4047
PRODUCT SPECIFICATIONS and GETTING STARTED
• Two (2) 90°-angle brackets
• Canopy and three (3) screws
• Four (4) black screws
• Wall T-stat with 20' wire
• Hand held Thermostat Remote w/receiver
• Manual shutoff valve
• Sediment trap
• Tee joint.
• Pipe wrench
• Trim kit
• Two (2) anchoring screws
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents