Map Screen Operation; To Display Map Screen - Toyota Touch & Go Owner's Manual

Touch_Go_Plus_OM20B71E.book Page 24 Thursday, September 20, 2012 12:03 PM
1. NAVIGATION OPERATION

3. MAP SCREEN OPERATION

TO DISPLAY MAP SCREEN

1
Press the "MAP NAV" button.
When the "MAP NAV" button is pressed,
any of the "Navigation" screens is dis-
played, press the "MAP NAV" button
again.
2
Touch "Confirm".
After about a few seconds, the caution
screen automatically switches to the map
screen.
INFORMATION
The caution screen will be displayed
when the screen is changed to the map
screen for the first time after the engine
switch has been in the "ACC" or "ON"
position.
24
Display audio_Ext_EE

MAP SCREEN OPERATION

CURRENT VEHICLE POSITION
DISPLAY
When starting the navigation system,
the current position is displayed first.
This screen displays the current vehi-
cle position and a map of the surround-
ing area.
The current vehicle position mark
appears in the centre of the map screen.
INFORMATION
While driving, the current vehicle posi-
tion mark is fixed on the screen and the
map moves.
The current position is automatically set
as the vehicle receives signals from the
GPS (Global Positioning System). If the
current position is not correct, it is auto-
matically corrected after the vehicle
receives signals from the GPS.
After 12-volt battery disconnection, or on
a new vehicle, the current position may
not be correct. As soon as the system
receives signals from the GPS, the cor-
rect current position is displayed.