Pioneer PDR-509 Service Manual page 57

6.5.4 Focus Bias Adjustment
Test Point CN102 - pin 1 (RF)
Adjustment Point
Adjustment Value
Symptom when out of
adjustment
[Procedure]
(1) Press the DIGITAL SYNCHRO button in Stop mode.
Note: Make sure the unit is in Stop mode.
(2) Check that "48" appears on the FL display.
(3) Press the AUTO/MANUAL button so that "04 34" appears on the FL display.
(4) Press the FINALIZE button for focus-in.
(5) Press the PLAY button for CAV-servo spindle kick.
(6) Press the PAUSE button to close the tracking servo, then set the unit to Playback mode.
(7) Adjust with the RDIGITAL REC LEVEL knob until the above adjustment value to be reached is obtained.
Press the DIGITAL REC LEVEL knob to register the adjustment. Once the adjustment is registered with the DIGITAL REC LEVEL knob,
"?" on the FL display will disappear.
(8) Press the STOP button to stop the unit.
RF
10 : 1
VC
10:1 probe
Note: Adjustment must be done around mid-radius on a disc.
DIGITAL SYNCHRO button, DIGITAL REC LEVEL knob
Adjust until RF jitter is minimal or that the eye pattern of the RF waveform is most open.
Sound broken, record characteristics deteriorate
Jitter Meter
or
Oscilloscope
PDR-509
Test Disc
STD-903
57