Table of Contents
Advertisement
Getting started
Battery installation & charging
After battery installation, place each handset in the telephone base or a charger
and allow it to charge for sixteen hours before use. You can keep the battery
packs charged by returning the handsets to the telephone base or chargers after
each use. When the battery is fully depleted, a recharge takes about sixteen hours.
The average talk time on a fully charged battery is about eight hours depending on
environmental conditions, and the standby time is approximately four days.
Press in and downward on
the tab to open the battery
compartment cover.
Plug power adapter into the jack
on the underside of charger as
shown, then plug into an electri-
cal outlet.
Caution: Use only the supplied rechargeable battery or replacement battery pack (part number 80-
5848-00-00).
NOTE: Use only the power adapter supplied with this product. If you need a replacement, call 1 (800)
222-3111. In Canada, call 1 (866) 288-4268. Be sure to use an electrical outlet not controlled by a wall switch.
Plug the battery
Place the battery
pack connector
pack and wires in
into handset.
the compartment.
Place handset in base or
charger to charge for sixteen
hours before first use.
9
9
Slide battery compart-
ment cover up until it
clicks closed.
LOW BATTERY
Low battery indicator
Return handset to base
or charger to recharge
when this symbol flash-
es. (Handset will beep
when battery is low.)
Advertisement
Table of Contents
