Pushing The Machine By Hand; Operating The Machine - Toro TimeCutter SS 4225 Operator's Manual

Adjusting the Tilt
You can adjust the motion-control levers fore or aft for your
comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft (Figure
3. Tighten both bolts to secure the control lever in the
new position.
4. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Do not
tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and to push
the machine, turn the ignition key to the R
battery needs to be charged and functioning to disengage
the electric brake.
Pushing the Machine
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, and wait for all moving
parts to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place
Note: Do this for each lever.
5. Move the motion-control levers inward to the
N position and turn the ignition key to the
EUTRAL
R position.
UN
Note: Do not start the machine.
Note: You can now push the machine by hand.
20).
position. The
UN
ARK
(Figure 21).
1. Bypass-lever locations
2. Lever position for

operating the machine

6. When finished, turn the key to the S
avoid draining the battery charge.
Note: If the machine fails to move, the electric brake may
still be engaged. If necessary, release the electric brake
manually; refer to Releasing the Electric Brake (page
Operating the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in
Note: Do this for each lever.
22
1 2
Figure 21
3. Lever position for pushing
the machine
position to
TOP
Figure 21.
3
g017303
36).