Driving Forward - Toro TimeCutter SS 4225 Operator's Manual

Driving Forward

Note: Always use caution when backing up and turning.
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion-control levers
forward (Figure 14).
Figure 14
To go straight, apply equal pressure to both
motion-control levers
To turn, release pressure on the motion-control lever
toward the direction you want to turn
The farther you move the motion-control levers in
either direction, the faster the machine moves in that
direction.
To stop, pull the motion-control levers to neutral.
G008952
(Figure 14).
(Figure 14).
Driving Backward
Note: Always use caution when backing up and turning.
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down, as you
slowly pull the motion-control levers rearward
15).
To go straight, apply equal pressure to both
motion-control levers
To turn, release the pressure on the motion-control
lever toward the direction you want to turn.
To stop, push the motion-control levers to neutral.
Using the Smart Speed
System
TM
The Smart Speed Control-System lever, located below the
operating position (Figure
to drive the machine at 3 ground speed ranges—trim, tow,
and mow.
1. Smart-speed lever
19
G008953
Figure 15
(Figure 15).
TM Control
16), gives the operator a choice
Figure 16
(Figure