Stopping The Machine; Adjusting The Height-Of-Cut - Toro TimeCutter SS 4225 Operator's Manual

To change speeds, do the following:
1. Move the motion-control levers to neutral and outward
to the P position.
ARK
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Transport
Trim
This is the lowest speed. The suggested uses for this speed
are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
Tow
This is the medium speed. The suggested uses for this speed
are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this speed
are as follows:
•
Normal mowing
•
Transporting the machine
Tow Mow
X
X
X
X

Stopping the Machine

To stop the machine, move the motion-control levers to
neutral and outward to the P
blade-control switch, ensure the throttle is between half and
full throttle, and turn the ignition key to off. Remove the
key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.

Adjusting the Height-of-Cut

Note: The transport position is the highest height-of-cut
position or cutting height at 115 mm (4.5 inches) as shown
in Figure 17.
20
position, disengage the
ARK
ARK
Figure 17
position