Advertisement
For Your Safety
To prevent damage to your product or injury to you or to others, read the
following safety precautions in their entirety before using this equipment.
Keep these safety instructions where all those who use this equipment
will read them.
Do not disassemble or modify
It has got high voltage storage capacitor inside. Failure to observe this
precaution could result in electric shock or product malfunction. Should the
product break open as the result of a fall or other accident, remove the batteries
and take the product to authorized maintenance center for inspection.
Keep dry
Do not handle with wet hands. Also, the product should not be immersed in or exposed
to water or rain. Failure to observe this precaution could result in fire or electric shock.
Keep out of the reach of children
This device contains small parts that may pose a choking hazard. Consult a
physician immediately if a child swallows any part of this device.
Do not expose to high temperature
Do not leave the device in a closed vehicle under the sun or in other areas
subject to extremely high temperature. Failure to observe this precaution
could result in fire or damage to the casing or internal parts.
Caution
The flash can be used at full power for 5 minutes continuous, and then it
should be cooled down for 2 to 3 minutes. Overheating will occur if it is used
continuously without cooling down.
Do not exceed 150 Watts for modeling lamp. The excess heat can damage the unit.
Do not keep long time in using the modeling light, otherwise the modeling
lamp will be deformed, and the flammable accessories such as soft box will
get burnt.
Do not touch the lamp bulb or tube with your bare hands. Oil residue from
your fingers can cause the surface of the lamp to heat unevenly and explode.
03
When using a snoot, do not keep long time the modeling lamp on, or over
frequent flashlight (not over six times for one minute). Overheating will result
in damages for strobe casing and studio light.
Do not touch the lampcap when the flash or lamp is working, as it will give out
heat, leading to high surface temperature.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
Do not flash directly towards naked eyes (especially those of babies),
otherwise it may lead to visual impairment.
When not in use, disconnect from the power supply.
Names of Parts
Body
12
11
10
9
8
1.Light Sensor
2.Charging Indicator Lamp
4.Test Button
5.Sync Cord Jack
7.Modeling Lamp Auto Selecting Switch Upwards: Auto On; Downwards: Auto Off
8.AC Power Socket
9.Modeling Lamp Switch
11.Power Indicator Lamp 12. Flash Output Controller
1
4
3
5
2
6
7
13
3.Power Fuse
6.Buzz Switch
10.Power Switch
13.Mounting Bracket
04
Advertisement
