Advertisement
Accessories
1.Sync Cord
(optional accessory)
2.Power Cord
3.Fuse Tube
4.Modeling Lamp
5.Reflecting Lamp Shade
6.Lamp Cover
7.Instruction Manual
Instrultions for Use
Flash Preparation
1.Take down the lamp cover.
Install the reflecting lamp
shade and modeling lamp.
2. Mount the flash unit on an
appropriate light stand and
adjust the mounting bracket
(13). Make sure it's tightened
and fixed.
Power Connection
Use the power cord to connect the flash to an AC power source and turn on the
power switch (10), power indicator lamp (11) lit. The charging indicator lamp (2)
is off when it is charging, no flash at this moment. The unit is ready to fire until
the charging indicator lamp (2) is on, meaning it is fully charged. Set the power
switch to OFF position when it is not in use.
Modeling Lamp
1. Modeling lamp switch (9) decides whether the modeling lamp is on or off:
Downwards (OFF position), it's off; upwards (MODE position), it's on.
2. Modeling lamp auto selecting switch (7) decides whether it's auto or not:
Downwards (DIM position), auto on; upwards (AUTO position), auto off. The
modeling lamp will turn off automatically when flash works.
Do not keep long time in using the modeling lamp. It's better to be cooled
down for 2 minutes after 5 minutes continuous use.
05
1
3
2
4
5
6
Flash Output Control
Flash output controller (12) controls the power radio to satisfy requirements of light
under different environment. (Note: When adjusting the power from full power to a
lower setting, press the test button to release the power in the capacitor, so when
recharged, the flash output will be in the corresponding setting.)
Test Button
To fire the flash without taking a picture, push the test button (4). It can also
adjust the brightness when combined with the flash output controller (12).
Sync Triggering
A sync cord (5) is
provided with your flash
unit, and the input is a
Φ6.35mm mini plug.
Insert a trigger plug here
and the flash will be fired
synchronously.
Slave Trigger Model
The flash will be fired synchronously with one external flash. This model can
act as an auxiliary lamp, offering various effects of light and shadow.
* The slave trigger model is shut down when the sync cord is in use.
Buzz Function
The device is equipped with buzz function. It is turned on when the buzz switch
(6) is set downwards, and then a "BI" sound will be heard when it is fully charged.
06
Advertisement
