Figure 9. Device Terminal Program - Wiznet WIZ6000 User Manual

※ The above test can also be performed in a program called, "Device Terminal program", which
is easy and simple to use.

Figure 9. Device Terminal Program

Device Terminal is a program which integrates both serial and network communications into one
user interface so that you can test your WIZnet gateway module easily.
As shown in above Figure, the upper part of the program allows you to configure your serial
setting of WIZ6000. By clicking the "Open" button, serial communication is enabled.
The lower part of the program allows you to configure the network settings. You can test both
TCP Client and TCP Server modes at the same time. If the Server Mode is enabled, Device
Terminal will operate as server mode, and the WIZ6000 module will work as client mode. The
PC where the Device Terminal is operating will work as a server, the IP address of the PC
should be set as Server IP of the module. If Server mode is not checked, Device Terminal will
operate as client mode, and the module as server. For the IP address and port, please input
your IP address and port number of WIZ6000 and click the "Connect" button to start a network
communication.
When serial and network terminals are connected, input any character in the Data Input window
and click "Send" button. You can check the data is transferred into the another window.
11
(WIZnet Co., Ltd.)
WIZ6000 User's Manual