U-Line 3060FZR User Manual page 66

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
11.Grasp evaporator cover, pull the top forward and up as
bottom of cover is installed behind the front edge of
the drain trough.
12.While pulling the evaporator cover clear of the unit, it
may be necessary to use your free hand to manipulate
the fan plug end through the pass-through hole.
13.Remove the 4 screws mounting the fan shroud to the
evaporator plate.
14.Remove and replace fan. Take special care to properly
route fan wire.
NOTICE
Fan must be oriented to pull air in through lower
evaporator cover vents and push air out at fan
mounting location.
15.Installation is the reverse of removal.
16.Care must be taken to assure the bottom of the
evaporator cover is reinstalled behind the front edge of
the drain trough.
17.Use sealant gum to seal any openings at the rear of
the unit before replacing rear cover.
18.Reinstall unit taking care to level, space and secure as
found.
Air Flow
u-line.com
Remove Fan and Cover 2