Subscribe to Our Youtube Channel
Related Manuals for Metos EMS 9 INOX PM1
Summary of Contents for Metos EMS 9 INOX PM1
- Page 1 REFRIGERATED VERTICAL DISPLAY CABINET EMS PM, M Installation and user manual 8.5.2015 MG4310620, MG4310622, MG4310624, MG4310620MR, MG4310622MR, MG4310624MR, MG4310626, MG4310628, MG4310630, MG4310632...
-
Page 2: Table Of Contents
8.5.2015 Metos EMS TABLE OF CONTENTS GENERAL ..............................3 SAFETY PRECAUTIONS ..........................3 SERIAL DATA PLATE ..........................3 RECEIVING AND INSPECTING THE EQUIPMENT ...................3 INSTALLATIONS ............................4 5.1. Location ...............................4 5.2. Unpacking ..............................4 5.3. Ventilation ..............................4 5.4. Leveling ...............................5 5.5. Initial cleaning procedure ..........................5 ELECTRICAL INSTRUCTIONS ........................5... -
Page 3: General
8.5.2015 Metos EMS GENERAL Congratulations on your purchase. This refrigerator has been manufactured under strict quality controls and meets the high standards set by the manufacturer. Before shipping, each individual cabinet has been tested in order to assure a quality product. Furthermore, it has been produced with recyclable materials using an environmentally friendly process, making an active contribution to the preservation of our environment. -
Page 4: Installations
8.5.2015 Metos EMS INSTALLATIONS 5.1. Location This unit is intended for indoor use only. Be sure the location chosen for your unit must be able to provide good air circulation for most efficient refrigeration. Avoid locations near heat sources such as stoves, ovens, fryers, and also direct sunlight where tempe- ratures can reach extreme values. -
Page 5: Leveling
8.5.2015 Metos EMS 5.4. Leveling Its extremely important that the cabinet is perfectly level for proper operation so that the drain pan will drain properly, the doors will line up with the frames and the unit will not be subject to undue strain. -
Page 6: Operation
8.5.2015 Metos EMS Before loading product, we recommend to run the unit empty during 24 hours. The air curtains are designed for exposition of product and maintain the temperature in: • H1: +4ºC / +8ºC, Climate class 3 (+25ºC, 60%HR). For Fruits and Vegetables. -
Page 7: Defrost Control
8.5.2015 Metos EMS 8.2. Defrost control The defrost timer is preset for a defrost period. These models have a hot gas defrost system which works by routing superheated compressor discharge gas directly to the evaporator, avoiding any accumulation of frost. -
Page 8: Loading Product
8.5.2015 Metos EMS 8.3. Loading product • Before introducing food into the cabinet, it is advisable to leave it empty while in operation until it reaches the working temperature. Once this has been reached, you can proceed to load the equipment. -
Page 9: Parts And Service
8.5.2015 Metos EMS • Heavier dust build up may require compressed air to blow through the condenser coil. • Replace the condenser cover, slide condensing unit back into position and tighten all screws. • Finally, replace the lower rear panel and reconnect electrical power supply. - Page 10 8.5.2015 Metos EMS PROBLEM POSSIBLE SOLUTION Compressor starts and runs, but cycles on overload 1.- Low voltage. 2.- Running capacitor defective. 3.- Overload protector defective. 4.- High head pressure. 5.- Fan motor, pump, etc… , wire to wrong of overload protector.
-
Page 11: Warranty
8.5.2015 Metos EMS 10. WARRANTY Dear user: You must receive the warranty certificate duly filled out within a maximum period of 20 days from the purchase date so that the equipment you have just purchased may benefit from the warranty specified in this document. -
Page 12: Consumers' Legal Rights In The Case Of Contractual Lack Of Conformity
8.5.2015 Metos EMS 10.2. Consumers’ legal rights in the case of contractual lack of conformity 1. The manufacturer shall be liable to the consumer for any lack of conformity with contract of sale, ef- fective when the product is sold. The product shall be deemed as compliant with the contract where it observes the following requirements: a) It matches the manufacturer’s description and has the qualities stated by said manufacturer in the... -
Page 13: Technical Information
8.5.2015 Metos EMS 11. Technical information EMS 9 EMS 12 EMS 18 EMS 9 EMS 12 EMS 18 INOX PM1 INOX PM1 INOX PM1 INOX PM1 INOX PM1 INOX PM1 (marine) (marine) (marine) Code MG4310620 MG4310622 MG4310624 MG4310620MR MG4310622MR MG4310624MR... - Page 14 8.5.2015 Metos EMS...
- Page 15 8.5.2015 Metos EMS...
Need help?
Do you have a question about the EMS 9 INOX PM1 and is the answer not in the manual?
Questions and answers