Connecting Remote Receiver - Monessen Hearth DEB30 Installation And Operating Instructions Manual

CONNECTING REMOTE RECEIVER

1. Connect the connectors to the two .25" male con-
nectors located on the right side when facing the
unit (Figure 19). Do not let the wire touch the grate
or burners.
NOTE: Heat reduces battery life. You can
protect the receiver and extend battery life
by mounting the receiver in a wall or other
location outside the fi replace.
INSTALLING T-STAT SENSOR (OPTION SOLD SEPARATELY)
1. Remove metal bracket and label from box.
2. Peel away the paper backing on the label. Line up holes in label with holes on the bracket. Right side of label should
flush with right side of bracket. See Figure 20. Press label firmly and smoothly to bracket.
3. Using Phillips screwdriver, install t-stat sensor to bracket with two screws provided. See Figure 21. Make sure the
thermo bulb wire is at the bottom of t-stat sensor.
4. Plug in wiring harnesses to back of t-stat sensor. See Figure 21.
T H
E R
M O
S E
T T S T
I N
G
Line Up
Holes
2 6
D 3
3 1
7
Figure 20 - Applying Label to Bracket
44D0060
A T
H I
G H
L O
W
Flush edge of label to
right side of bracket
ELECTRICAL WIRING (MILLI-VOLT)
Remote
Receiver
Figure 19 - Installing Remote Receiver
T-Stat
Sensor
Bracket
T H
E R
M O
S E
T T S T
I N G A T
H I
G H
2 6
D 3
3 1
7 L O
W
Screws
Figure 21 - Installing T-Stat Sensors
and Wiring Harnesses
Remote
Wire
Connectors
Wiring
Harnesses
Thermo Bulb
23