Pilot; Optional Remote Receiver - Monessen Hearth VDY24/18 Installation And Operating Instructions Manual

REMOTE RECEIVER INSTALLATION
DO NOT PLACE THE REMOTE IN THE FIREPLACE IF ANY OF THE FOLLOWING CONDITIONS APPLY.
• The floor of the fireplace is recessed below the fireplace opening. Refer to the "Warnings" on page 7.
• The fireplace has a glass doors which when open reduce the fireplace opening width by 1
minimum dimensions within the homeowner's manual.
• The floor of the fireplace is sheet metal without a brick covering.
• The remote receiver when attached does not physically fit inside the fireplace with 2" clearance to the side wall.
1. Cut wire to length (approximately 5" for placement in the fireplace). Strip back
the wire. Connect two 1/4" spade terminals to one end of the wire. Insert the opposite end of the wire into the receiver
wire terminals and tighten the screws. The female terminals should be connected to the factory attached male terminals
located on the right hand side of the control cover. (See Figure 28). Do not let wire touch grate and/or the burner.
THTP

Pilot

2. Attach Velcro pad to side of remote receiver (op-
posite battery cover) with self adhesive backing.
3. Attach second Velcro pad to control bracket with
self adhesive backing. (See Figure 29).
4. Attach remote receiver to control cover.
FAILURE TO FOLLOW THESE INSTRUCTIONS
EXACTLY AND/OR TO PLACE THE REMOTE
RECEIVER IN ANY LOCATION WITHIN THE
FIREPLACE OTHER THAN THE RECOM-
MENDED LOCATION WILL VOID THE WAR-
RANTY AND COULD CAUSE THE RECEIVER
UNIT TO MELT.
NOTE: Battery life decreases as temperature
increases. If the remote requires frequent
battery changes, this problem can be
improved by placing the remote receiver
outside of he fireplace in an area with
lower temperatures.
32D1999
TP
TH
Optional Wall
Switch or Remote
Receiver
Figure 28 - Millivolt Wiring Diagram

OPTIONAL REMOTE RECEIVER

1
1
/ " of the insulation from both ends of
4
Milli-volt Valve
Switch
Factory Attached Wiring
Figure 29 - Placement of
Remote Receiver on VDY Log Set
/ " or more below the stated
2
Remote
Receiver
Wiring
21