Hints For Correct And Safe Operation; Handling The Discs - Sanyo FXD-C200 Operating Instructions Manual

HINTS FOR CORRECT AND SAFE OPERATION

This CD Changer is designed to be operated only on +12 volt DC negative ground systems. The unit can not be
used on +24 volt or positive ground systems.
protection circuit. When the temperature reaches a pre-set level, the protection circuit halts all unit operation. If
this should happen, open a window and allow the car to cool.
Condensation
Moisture can condense on the laser lens, of the CD changer during rainy and humid days, or right after the heater
is turned on in the car. If this should happen the unit will not operate correctly. To remedy the situation, remove
the discs from the unit and wait approximately one hour. During this time the moisture will evaporate and the unit
will operate normally.
'INTERRUPTIONS IN SOUND (Skipping)
The sound from the unit may "skip" and be interrupted, if the anti-vibration springs are not set correctly, if the unit is
mounted in excess of a 15' angle, or on very rough road surfaces. If this should occur check for errors made dur-
ing installation or wait for the road surface to improve.
Remove the magazine from the unit when it is not being used during hot weather. If the discs are left in a extreme-
ly hot car they may warp. If the CD changer is not used for long periods of time, remove the compact discs from
the magazine, and store them in their case.
When playing an 8cm disc, a separately available magazine (MGN-12 06) should be used instead of using the
adaptor. The 8cm disc adaptor must never be used, or the internal mechanism may break.

HANDLING THE DISCS

Dirt, dust, scratches and warpage
How to take care of your discs:
1. Use compact discs that have the mark shown on the right.
2. Fingerprints and dust should be carefully wiped off the disc's signal surface (glossy side) with a soft cloth. Unlike
conventional records, the compact disc has no grooves to collect dust and microscopic debris, so gently wiping with
a soft cloth should remove most particles. Wipe in a straight motion from the inside to the outside of the disc. Small
dust particles or light stains will have absolutely no effect on reproduction quality.
3. Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean compact discs.
Such chemicals would irreparably damage the disc's plastic surface.
4. Discs should be put back in their cases after use to avoid serious scratches that could cause sound skip.
5. Do not expose discs to direct sunlight, high humidity. or high temperatures for extended periods of time. Long expo-
sure to high temperatures can warp the disc.
6. Do not stick paper or write anything with a ball-point pen on the disc surface.
cause sound skips during playback and a deterioration of sound quality.
D I G I T A L A U D I O