Specifications - Makita HP2010N Instruction Manual

ENGLISH

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-1:
Sound pressure level (L
Model
Speed
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Safety class
equipment and
environmentally compatible
) : 97 dB(A)
pA
14 mm
6.5 mm
20 mm
0 - 2,300
0 - 46,000
END201-2
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745-2-1:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : drilling into metal
Vibration emission (a
its
EC-DECLARATION OF CONFORMITY
Model; HP2010N
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
ENE039-1
000230
ENF002-1
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENG102-1
2
HP2010N
High
350 mm
3.0 kg
/II
) : 108 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 13.0 m/s
h,ID
2
) : 2.5 m/s
h,D
CE2007
Tomoyasu Kato
Director
Low
20 mm
13 mm
40 mm
0 - 900
0 - 18,000
ENG203-1
vector sum)
2
ENG302-1
2
or less
ENH101-8