Control Panel And Knobs; Glass Surfaces; Painted Surfaces - GE JRS04 Use And Care Manual

Proper care and cleaning are important so your oven will give you efficient
and satisfactory service. Follow these directions carefully in caring for your
oven to assure safe and proper maintenance.

Control Panel and Knobs

It's a good idea to wipe the control panel after each
use. Clean with mild soap and water or vinegar and
water, rinse with clean water and polish dry with a
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
panel-they will damage the finish. A 50/50 solution
The control knobs may be removed for easier
cleaning. Before removing the knobs for cleaning,
please note that the knobs on the left side and the
knobs on the right side are in the proper OFF position.
W-hen replacing the knobs, check the OFF position to
insure proper alignment.
To
remove a knob, pull it straight off
knob is difficult to remove, place a thin cloth (like a
handkerchief or a piece of string under and around
the knob edge and pull up.
Wash the knobs in soap and water but do not soak.
Avoid getting water in to the knob stem holes.

Painted Surfaces

Painted surfaces include the control panel. Clean
these with soap and water or a vinegar and water
solution. Do not use commercial oven cleaners,
cleansing powders, steel wool or harsh abrasives
on any painted surfaces.
Oven Heating Elements
Do not clean the bake element or the broil element.
Any soil will burn off when the elements are heated.
The bake element can be lifted gently to clean the
oven floor. If spillovers, residue or ash accumulate
around the bake element gently wipe around the
element with warm water.
the stem. If a

Glass Surfaces

To clean the outside glass finish, use a gluss cleaner.
Rinse and polish with a dry cloth. Do not allow the
water or cleaner to run down inside the openings in
the glass or the openings in the top of the oven door
while cleaning.
Broil Element
Bake Element