Danfoss TP9000 User Manual page 25

to the above all of the Installer Advanced Programming settings are
returned to factory settings, however, time, date and service due
date are not reset.
Installer Settings
Option Description
Option 30 Set upper limit of temperature range
Option 31 Set lower limit of temperature range
Option 32 Enable Off at lower limit
Option 33 Enable On at upper limit
Option 34 Select On/Off or Chrono-proportional
Option 35 Set Integration Time
Option 36 Set temperature override rule
Option 37 Set time duration of override rule
Option 40 Number of events per day (Heating)
Option 41 Operating mode (Heating)
Option 60 Number of events per day (Hot Water)
Option 61 Operating Mode (Water)
Option 70 Keyboard disable rules
Option 71 Random start rules
Option 72 Owner site reference number
Option 73 Owner thermostat reference number
Option 74 Date format for calendar clock
Option 80 Enable/Disable + hrs boost
Option 81 Thermostat calibration bias
Option 90 Defi ne remote sensor type
Option 93 Set limit sensor set-point
Option 94 Confi gure digital input switch type
User Settings
Option Description
Option 1 Enable/disable A/B programming
Option 2 Enable/Disable advanced programming
Option 3 Calendar clock rules
Option 4 Time zone off set
Option 10 Frost/thermostat mode setting
Option 11 Start-up method
Option 12 Optimum start control pre-heat setting
Option 13 Optimum start control/delayed start event
setting
Danfoss Heating
Installer Setting
User Settings
GB GB
PL
GR
ES
25