Table of Contents
Advertisement
Logitech Harmony 890 User's Guide
E. LOCATING THE IR EMITTERS
To use the IR emitters, do the following:
Locate the device's IR sensor (this is the area (1), usually on the front panel of the device, where
•
IR signals are received).
Uncover the adhesive strip (2) and attach an emitter directly to this area, or – if you do not want
•
to place an emitter directly on the device – attach the emitter on a surface above, below or in
front of the device, but in a line of sight to the IR sensor. Inside a cabinet, the IR emitter can
also be attached to a door in front of the device (3).
Each emitter cable has two IR emitters on one end, and can control either one or two devices. If
•
only one is needed, leave the other emitter unconnected. Plug the other end of the emitter cable
into one of the four ports on the Wireless Extender (4).
Your Harmony 890 remote should now control all devices as programmed, whether by IR or RF
signals.
Draft Sample Layout and Chapter 8 for Logitech, 2-13-08
Copyright Reed Consulting Services
Golden, Colorado
Page 18 of 20
Chapter 11: Using the RF Wireless Extender
(303) 526-2465
Advertisement
Table of Contents
