Hunter Type 2 series Owner's Manual And Installation Manual page 14

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-10. Remove the lower switch housing screws, then remove the lower
switch housing.
7-11. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the red wire.
7-12. Disconnect the plug connectors between the two white wires.
7-13. Uninstall the nut and washer from the end of the light fixture
inside the lower switch housing.
7-14. Unscrew the threaded rod of the light fixture from the lower
switch housing.
7-15. Remove the light fixture from the lower switch housing, pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through first, and then pull the other plug connector
(female) through the hole.
7-16. Install the dummy terminals (included in the sack parts) on the
two disconnected wires in the lower switch housing.
7-17. Install the switch housing cap and plug button to the
lower switch housing.
7-18. Re-attach the lower switch housing back to the fan and
reinstall the lower switch housing screws.
13
45058-01 • 08/13/09 • Hunter Fan Company
Threaded Rod
Steps 7-12 – 7-16
Cap
Plug Button
Lower Switch
Housing
Step 7-17