Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable; Remote Control Handset; Inserting Batteries - Technika 16-850 Operating Instructions Manual

Connecting to a DVD Player via
HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable
• Some DVD players are connected through
COMPONENT SOCKETS (YPbPr).
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
• When the connection is made, switch to YPbPr
source. See, "Input selection" section.
• To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match ( RED &
• When the connection is made, switch to
See, Input selection section.
• You may also connect through the
HDMI socket, you can
HDMI Cable
(not supplied)
External device
YPbPr can be
VGA/
WHITE).
YPbPr source.
SCART input.
English - 10 -
Scart Cable
(not supplied)
External device
• Note : These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.