GE 27936 User Manual page 17

From the Handset:
1. Make sure the phone is OFF (not in TALK mode).
2. Press the int (intercom) button on the handset. A paging tone sounds at
the base and from the handset. PAGING shows in the display. (To cancel
intercom, press the int button again.)
3. Wait for the person near the base to press the PAGE/intercom button.
When the PAGE/intercom button on the base is pressed, INTERCOM
shows in the display.
NOTE: After 15 seconds of paging, if the page is not answered at the base, the
base intercom turns on and the person using the handset may listen to what is
happening in the room where the base is located. The person using the handset
may also speak into the handset and be heard through the base's speaker.
4. When finished, press int on the handset or PAGE/intercom on the base
to stop using the intercom.
NOTE: The base must be within range of the handset for the intercom to
function. If the base is in use, BASE IN USE shows on the handset display.
From the Base:
1. Make sure the phone is OFF (not in SPEAKERPHONE mode).
2. Press the PAGE/intercom button. A paging tone sounds at the
handset. (To cancel intercom, press PAGE/intercom again.) PAGING
shows in the display.
3. Wait for the person with the handset to press the int button. When the
int button is pressed, INTERCOM shows in the display.
4. When finished, press the PAGE/intercom button on the base (or int on
the handset) to stop using the intercom.
NOTE: The handset must be within range of the base unit in order for
intercom to function. If the handset is in use, you will hear a beep from the
base unit.
17