Table of Contents
Advertisement
SPECIFICATIONS
DATA CAPACITY
(bytes/block)
ROTATIONAL SPEED
SUSTAINED DATA
TRANSFER RATE (kbytes/sec)
ACCESS TIME (Typ.)
Avg. Random Access
Avg Random Seek
Avg. Full Stroke
DATA BUFFER
POWER SUPPLY
MTBF
DIMENSIONS (Wx H x D)
WEIGHT
MOUNTING ORIENTATION
TECHNICAL SUPPORT
Technical support can be obtained by calling 949/455-0407 or by sending an
email to: toshibadpd@telecplan-ventura.com or visiting our website at:
FCC DECLARATION OF CONFORMITY
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part
15 of the FCC Rules.
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV
reception. The user is cautioned that changes and modifications made to the equipment without the approval of
the manufacturer could void the user's authority to operate this equipment.
LASER CAUTION
This appliance contains a laser system and is classified as a "CLASS 1 LASER PRODUCT". To use this model
properly, read this Owner's Manual carefully and keep this manual for future reference. In case of any trouble with
this model, please contact your nearest "Authorized Repair Center". To prevent direct exposure to the laser beam,
do not try to open the enclosure
DVD-R: 1,100 - 2,800rpm
http://www.sdd.toshiba.com
These limits are designed to provide reasonable protection against harmful interference
SD-R1002
DVD
2,048
DVD: 2,800rpm
(2 - 4.8X CAV)
(2X CLV)
2,704 - 6,536
160ms
140ms
230ms
2Mbytes
+5v, +12v
100,000 hours
5.7" x 1.6" x 7.6" (146mm x 41.5mm x 193mm)
0.58lbs ( 0.98kg)
±10° vertical / ±20° horizontal
CD
mode 1
mode 2
2,048
2,336
CD: 5,100rpm
(10.3 - 24 CAV)
CD-RW: 3,400rpm
(6.9 - 16X CAV)
CD-R, CD-RW (Write):
850 - 1,980rpm (4X CLV)
mode 1
mode 2
1,552 - 3,600
1,770 - 4,106
110ms
105ms
180ms
7
Advertisement
Table of Contents
