GE JSP46 Installation Instructions Manual page 10

Installation Instructions
Installing the Range
E
Final Check of the Anti-Tip Bracket
When installation is
E9
complete and the
range is in place,
inspect to be sure
the rear leveling leg
is fully inserted into
the slot of the Anti-
Tip Bracket.
CAUTION: The oven door is heavy.
You may need help lifting the door
high enough to slide it down onto
the hinges. Do not lift the door by
the handle.
Replacing the Oven Door
Make sure the hinge is in the broil
E10
stop position.
Grasp the door on both sides.
E11
Lift the door over the hinges lining up
E12
the hinges with the hinge slots on the
bottom of the door.
Slide the door down onto the hinges
E13
as far as it will go and close the door.
(Cont.)
Replacing the Storage Drawer
Place the
E14
drawer rail on
the guides.
Push the
E15
drawer in until
it stops.
Lift the front of the drawer and push in
E16
until the stops clear the guides.
Lower the front of the drawer and
E17
push in until it closes.
SPECIAL INSTRUCTIONS IF YOU
HAVE PROBLEMS WHILE
REPLACING THE STORAGE
DRAWER
IF DRAWER WON'T CLOSE
Remove and replace, making sure the power
cord is not obstructing the drawer and/or the
rail is in the guide.
IF DRAWER IS CROOKED
Remove and replace making sure the rail is in
the guide.
10
Stop