Peripheral Configuration Submenu; Figure B-4. Peripheral Configuration Submenu; Table B-5. Peripheral Configuration Submenu Options - Dell Dimension L Series Reference And Troubleshooting Manual

support.dell.com

Peripheral Configuration Submenu

Figure B-4. Peripheral Configuration Submenu

Table B-5. Peripheral Configuration Submenu Options

Option Function
Serial port A Configures the serial port. Set this option to Auto (default),
Enabled, or Disabled. If set to Enabled, you can set the fol-
lowing additional options:
Base I/O O Available base I/O addresses are 3F8, 3E8, 2F8, and 2E8.
Address
Interrupt Available interrupts are IRQ3
Parallel port Configures the parallel port. Set this option to Auto (default),
Enabled, or Disabled. Depending on the port setting, you
can set the following additional options:
Mode If Parallel Port is set to Auto or Enabled, available modes
are Output Only, Bi-Directional (default), ECP , and EPP .
NOTE: Refer to the device manufacturer's documentation
for information on which mode to use before changing this
setting.
Base I/O If port is set to Enabled, available base I/O addresses are
378 (default), 278, and 228.
Address
Interrupt If port is set to Enabled, available interrupts are 7 and 5.
NOTE: The Glossary in the system Help defines abbreviations and acronyms.
RQ3 and IRQ4.
before changing this
System Setup Program B-7