Drain Hose Routing - GE GSS1800H Series Installation Instructions Manual

Position, Align, and
Level the Dishwasher
Before moving the dishwasher into the opening:
• Adjust the front levelers so the top of the machine
1
is / " below the underside of the countertop
4
( see Figure 9 ).
• Using a hex end wrench or
rear levelers to level the dishwasher from front to
back.
You can now move the dishwasher into the opening
and align it with the cabinets. Use caution when
moving the appliance to prevent damage to floor
coverings and adjacent cabinets.
• Align the front of the dishwasher as flush as
possible with front of the cabinets.
• Align the dishwasher so that the amount of space
is the same on each side and the same from top
to bottom.
NOTE: Double check the levelers to make sure
they set firmly against the floor. Leveling is
necessary for proper function of the dishwasher.
You are now ready to proceed with the final drain,
water, and electrical connections.

Drain Hose Routing

Be sure the hose is routed behind the dishwasher
motor and legs ( see Figure 10 ). Place the excess
hose flat on the floor in the dishwasher opening.
NOTE: Be sure there are no sharp bends, kinks,
or twists in the drain hose.
Electrical Shock Hazard
Disconnect electrical power at the fuse
box or circuit breaker box before installing
dishwasher.
Make sure that the water supply line, drain
hose, and wiring do not touch any
exposed terminals of the dishwasher
wiring.
Failure to follow these instructions could
result in death or serious injury.
3
/ " socket, adjust
16
Do not use dishwasher until completely
installed.
Do not push down on open door.
Doing so can result in serious injury or
cuts.
Hex End Wrench or
3 / " Socket
16
Motor
9
Tip Over Hazard
Figure 9
Drain Hose
Dishwasher Leg
Figure 10