10
Care and maintenance
10
Servicing and maintenance intervals
.01
Clean the looper compartment ..................... daily, several times if in continuous operation
Clean the entire machine ..................................................................................once a week
Machine oil level...........................................................................................daily before use
Control/adjust air pressure .................................................................................. as required
Clean air fi lter of the lubricator/air-fi lter ............................................................... as required
10
Cleaning the machine
.02
The cleaning cycle required for the machine depends on following factors:
● Single or several shift operation
● Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
Fig. 10 -01
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated more than this, shorter inter-
vals are recommended.
For all cleaning work the machine must be disconnected from the mains
by switching off the on/off switch or by removing the mains plug!
Danger of injury if the machine suddenly starts up .
Care and maintenance
To avoid breakdowns, the following cleaning
work is recommended for single shift ope-
ration:
● Open the looper cover.
● Clean the hook compartment 1 daily,
several times if in continuous use.
● Close the looper cover !
1
Do not run the machine with
the looper cover open.!
Danger of injury by moving
parts.
31