Toyota Land Cruiser Prado 2013 Owner's Manual page 650

651
8-2. Steps to take in an emergency
Inflate the tire until the recom-
11
mended pressure is reached.
The sealant will be injected
1
and the pressure will spike
to 300 kPa (3.0 kgf/cm
bar, 44 psi) or 400 kPa (4.0
kgf/cm
gradually decrease.
The air pressure gauge will
2
display the actual tire infla-
tion pressure about 1 minute
after the switch is turned on.
• Turn the compressor switch
off and then check the tire
inflation
careful not to over inflate,
check and repeat the inflation
procedure until the recom-
mended tire inflation pressure
is reached.
• If the needle of the air pressure gauge reaches the red zone (450
kPa [4.5 kgf/cm
in the tire or in the kit itself. Stop operation immediately.
• If the tire inflation pressure is still lower than the recommended level
after inflation for 10 minutes with the switch on, the tire is too dam-
aged to be repaired. Turn the compressor switch off and contact any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
• If the tire inflation pressure exceeds the recommended level, let out
some air to adjust the tire inflation pressure. (P. 655)
Disconnect the hose from the valve on the tire and then pull out the
12
power plug from the power outlet socket.
To spread the liquid sealant evenly within the tire, immediately drive
13
for about 5 km (3 miles).
LC150_OM_OM60K29E_(EE)
2
or
2
or bar, 58 psi), then
pressure. Being
2
or bar, 65 psi] or more), there may be a malfunction