Dvd Mechanism Deck (Cdm85-Dvbu102) - Sony HD-X1 Service Manual

HCD-X1

3-8. DVD MECHANISM DECK (CDM85-DVBU102)

PRECAUTION WHEN REMOVING GOOD OPTICAL PICK-UP BLOCK
Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging.)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
(Refer to DISASSEMBLY 3-2. OPTICAL PICK-UP BLOCK (KHM-310CAA))
optical pick-up block
PRECAUTION WHEN REPLACING DVD MECHANISM DECK
(CDM85-DVBU102)
1 Perform work with this wire (flat type) (24 core) connected,
or make a bridge as mentioned above and then disconnect the wire (flat type) (24 core).
(optical pick-up will be destroyed without bridging.)
On the contrary at the installation, connect the wire (flat type) (24 core) first,
and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
2 wire (flat type) (5 core)
(CN202)
6 three screws
(BVTP 3 × 8)
9 DVD mechanism deck
(CDM85-DVBU102)
16
wire (flat type) (24 core)
3 four screws
(BVTP 3 × 8)
4 DMB10 board
Note: Refer to SERVICING NOTES
" NOTE OF REPLACING THE DMB10 BOARD"
(page 6), when replacing the DMB10 board.
5 screw
(BV 3)
7 sub chassis
8 three screws
(BV 3)