Disassembly; Disassembly Flow; Optical Pick-Up Block (Khm-310Caa) - Sony HD-X1 Service Manual

HCD-X1
• This set can be disassembled in the order shown below.

3-1. DISASSEMBLY FLOW

SET

3-2. OPTICAL PICK-UP BLOCK (KHM-310CAA)

(Page 12)
Note: Follow the disassembly procedure in the numerical order given.
3-2. OPTICAL PICK-UP BLOCK (KHM-310CAA)
Note: The Cover (CDM) on the bottom of the set can be removed
when replacing the Optical Pick-up Block KHM-310CAA.
2 cover (CDM)
4 Lift up the holder (FFC).
5 two insulator screws
7 connector
9 optical-pick-up block
(KHM-310CAA)
6 Lift up the
optical-pick-up block.
12
SECTION 3

DISASSEMBLY

3-3. SIDE PANEL (L/R)
(Page 13)
3-4. CASE (AL)
(Page 13)
3-5. FRONT PANEL SECTION
(Page 14)
3-6. MAIN BOARD
(Page 15)
3-7. D.C. FAN (M450), BACK PANEL SECTION
(Page 15)
3-8. DVD MECHANISM DECK (CDM85-DVBU102)
(Page 16)
3-9. CHUCK CAM, BELT
(Page 17)
1 two screws
(PTP 3 × 8)
PRECAUTION WHEN REMOVING GOOD OPTICAL PICK-UP BLOCK
8 Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging.)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
5 two
insulator screws
3 two claws